N/A CSA certified for electrical equipment per C22.2, No. 14

N/A Engine

• Industrial, heavy-duty diesel engine is EPA emissions certified to current Tier III requirements.
• Electronically controlled engine provides isochronous frequency control and advanced diagnostic monitoring and protection.
• Oversized cooling system rated for high ambient operation.
• All filters and maintenance points are easily accessed enhancing serviceability.

• AREP brushless excitation provides powerful motor starting kVA and is isolated from harmonicinduced waveform distortion.
• Class H insulation for ultimate resistance to high temperature and humidity.
• Capable of supporting up to 300% overload for up to 10 seconds.
• R438 voltage regulator provides superior voltage stability and transient recovery.
• Single, sealed-for-life bearing ensures long maintenance-free performance.
• Generator features switchable voltage capability for operation at most common voltages.

• Operator-preferred analog gauges provide at-a-glance monitoring of vital engine and generator parameters (digital control system optional).
• Solid state engine control module provides convenient, microprocessor-controlled startup at the push of a button and protects the generator system from an array of faults while providing the operator with indication of any faults on the LED display.
• Standard remote Auto Start / Stop capability via two wire, closed contact logic, allows for connection to automatic transfer switchgear and other remote starting devices.
• Voltage selector switch (VSS) is protected by a safety shutdown device to prevent access and switching while generator is operating.

• All controls and connection points are grouped at the rear of the unit for safety and operator convenience.
• Power cables are connected at a five lug (L1 L2 L3 N PE) terminal board and accept bare end or terminated cables. Cam-lock connectors are optional.
• Convenience receptacles included standard, each protected by individual branch circuit breakers (see chart below for configuration).

• Single wall steel fuel tank is mounted within the skid base, providing double wall protection and 110% environmental containment of all fluids.
• The fuel filler is lockable and is located within the containment basin, minimizing possible spillage.
• Standard fuel / water separator and fine micron fuel filter keep contaminates out of the systemand increase reliability.

• The heavy duty enclosure provides weather protection of components and provides sound attenuation for use in noise sensitive areas.
• The enclosure is coated with a 13 stage paint process including E-coat primer for superior corrosion resistance and a high gloss powder paint for long life.
• The engine generator assembly is mounted on fail-safe vibration isolators.
• Wide opening side access doors are hinged, providing easy access and are equipped with recessed, pad-lockable handles.
• Package is equipped with a center-point lifting eye for safe, well-balanced hoisting.

• G185 is covered by a comprehensive limited warranty:
  • Package: 1 year / 2000 hours
  • Engine: 2 years / 4000 hours
  • Alternator: 2 years / 4000 hours
• Extended warranty options are available

N/A

• AC Voltmeter with phase selector switch
• Range: 0-600 V, 2% Accuracy
• AC Ammeter with phase selector switch
• Range: 0-600 A, 2% Accuracy
• AC Frequency meter
• Range: 45-65 Hz, 3% Accuracy
• DC Voltmeter
• Range: 8-16 V
• Fuel tank level gauge
• Range: 0-1/2-1/1
• Runtime hour meter
• Range: 0-99999.9 h
• Fine voltage adjustment control (+/- 5%)
• Overcurrent relay reset
• Control panel lamp

N/A

• Status Indications (Green)
• System On
• Preheat Cycle On
• Engine COM OK
• AutoStart Mode Active
• Shutdown Indications (Red)
• Low Oil Pressure
• High Coolant Temperature
• Engine Fault
• Overspeed
• Overcrank
• Low Fuel Level
• Warning Indications (Red)
• Low Battery Alarm
• High Containment Alarm